Start that Engine with a Battery

By Dr. David Cave
Published on November 10, 2026
article image
by David Cave

All of us have had one of those cantankerous low-tension magneto engines that’s difficult to start. Often, we resort to using a battery and coil or hot-box to get it started.

It’s kind of a nuisance. Before I can start the engine, I must find a suitable coil, a battery that is fully charged, and three usable jumper wires. Then, set everything on the ground beside the engine, disconnect the magneto and connect the battery and coil. In Figure 1, the positive (+) battery terminal is connected to a terminal of the coil with a red wire. The negative (-) battery terminal is connected to ground (the engine block) with a yellow wire. Finally, the other terminal of the coil is connected to the igniter with a black wire. One doesn’t need to worry about the battery connections as they can be reversed.

I’ve often wondered why I bother to dig out an extra coil when there’s already one on the engine – the magneto armature. As stated in several Gas Engine Magazine and Farm Collector articles, the key to a good spark from a magneto is the amount of current flowing in the armature coil when the igniter trips. Could a battery be used to boost the magneto’s current in the armature coil? Yes, it can, with one important caveat.

Figure 2 shows an illustration of the simple connection of a battery to the magneto and igniter to start that stubborn engine. Notice that now only a battery and one extra jumper wire is needed. The battery terminals (+/-) are unlabeled because whether the positive (+) terminal connects to the magneto or to the igniter is unimportant. Notice the magnet is removed from the magneto.

Before using the armature coil, check the magneto resistance. To be on the safe side, it should be at least 4Ω or greater to limit the current to 3A or less in the armature’s fine wire. Most magnetos will have 4Ω or more. Finally, never use a battery larger than 12V.

First, pull the magneto magnet off, then connect the magneto output to one terminal of the battery, and finally, connect the other terminal of the battery to the igniter. Start the engine. A 3hp John Deere is running on a battery and armature coil in Figure 3.

Once the engine is running, quickly disconnect the battery and connect the magneto output to the igniter. Lastly, reinsert the magnet before the engine spins down.

Warning: The caveat is to not have the battery connected and the magnet on the magneto at the same time. Why is that? When the battery is connected, the armature becomes an electromagnet with a north and south pole. During half of the magneto’s rotation the north pole of the armature electromagnet is aligned with the south pole of the magneto magnet. That’s good. The armature electromagnet is trying to recharge the magneto magnet. But, during the other half of the magneto rotation the armature electromagnet south pole aligns with the south pole of the magneto magnet. That’s bad. It’s trying to demagnetize the magneto magnet. This magnetize-demagnetize process quickly degrades the magneto magnet and a recharge might be necessary.


Engine enthusiast Dr. Dave Cave is a retired electrical engineer living in Arizona. He welcomes you to contact him at JDengines@cox.net

Online Store Logo
Need Help? Call 1-866-624-9388