Spark Plug Intensifier


| August/September 2003



Spark Plus Intensifier

'The object of my invention is to provide a spark plus intensifier of simple and durable construction so arranged as to not only make visible at all times the spark but to magnify the Spark.' George Richard Meissner, Specification of Letter Patent, filed Dec. 14, 1914.

Drawing from George Meissner's patent application shows the spark plug intensifier attached to the spark plug in its intended position ('Fig. 1' in the drawing). The drawings marked 'Fig. 2' and 'Fig. 3' are the contacts, 'Fig. 4' is the glass shell and 'Fig. 5' is an end cap for the shell, much like that on a brass oiler.

Three things are required to make an engine run; fuel, air and spark. Considering the simplicity of the formula, you'd think we wouldn't spend so much time building up our biceps by pulling on fly-wheels. Alas, many nuances intervene to adversely affect the trinity required to make an engine run, spark chief among them.

Spark

Early in the development of spark ignition, it became obvious there are factors that can prevent the spark from igniting the fuel/air mixture. One such factor is carbon fouling of the spark plug caused by incomplete combustion. In the worst case, the carbon creates a direct short across the spark plug's insulator, preventing the engine from running. But long before a spark plug becomes completely shorted carbon contamination has been slowly building and degrading the intensity of the spark, effectively reducing the engine's efficiency.

In the standard high-tension ignition circuit, the spark is not really instantaneous. It's very fast, but many things happen as the voltage builds. If we were to monitor the voltage in slow motion as the magneto fires, we would see the voltage rise from zero until it was sufficiently high to jump the gap on the spark plug. Depending upon many variables, this might happen at about 8,000 volts. The voltage then remains steady for a short period until the supply from the magneto is insufficient to maintain the spark. Clearly, a long duration spark has a better chance of igniting the fuel-air mixture.

In the ignition circuit with a contaminated plug, the contamination acts as a resistor, bleeding off the voltage as it builds. When the plug fires, it will be of shorter duration than if the spark plug was in good condition. If the contamination is bad enough, it will bleed off so much voltage that it never reaches the required intensity to jump the spark plug gap.