3012 S. Catherine, Lansing, Michigan 48911
I bought the Sears water pump at a swap meet with the thought that I could make an engine. I decided to open up the crank end and I made a new crankshaft with a three inch stroke. I used one inch roller bearings for the mains.
The bore in the pump was 2 inches and it was not too good. I made a 2 inch cast iron sleeve and pressed it in. I used a 2 inch iron piston from an old air compressor and a connecting rod from a Briggs.
I made the cart from scrap steel and a brass water tank and gas tank. The 14 inch flywheel weighs 20 pounds and came off an old post drill. The head I made from aluminum and is water-cooled. The intake and exhaust valves and spark plug are on a brass manifold on the side. The muffler is from a candle holder and the carb is from a brass gas cock. The aluminum flat pulley I got from an old air compressor. The governor I made from scrap brass and steel.
It starts easy and runs as slow as 160 rpm. I hope to take it to a few shows in 1995.