My Sideshaft Polish Meat Grinder Engine

| December/January 1996

Meat Grinder Engine

3012 S.Catherine, Lansing, Michigan 48911

I first saw this meat grinder in the flea market at the West Branch, Michigan, engine show.

It was different than others I have seen. It has a memorable hopper on top and 'Made in Poland' cast in the handle. It was the first one I ever saw that had the auger completely worn out. So, it was hard to imagine how many tons of Polish sausage had gone through it. I hauled it around for the rest of the summer and told people it was going to be my next engine. No one I showed it to could imagine how I was going to do it.

I got the steel for the base from a scrap store display rack. The brass flywheel I bought at the Wyandotte model show in 1992.

The small lubricator and grease cups I got at the Portland, Indiana, show. I bored out the meat grinder to fit a heavy steel wall tube with a needle bearing on each end for the main bearings.

I drilled a few shallow holes on the outside of the steel tube and poured babbitt inside the hopper to lock it in place. The oiler for the mains is inside the hopper.