Hercules Engine News

Including Economy, Arco, Jaeger & Thermoil

| June/July 1993

Webster magneto system

Webster magneto system.

20601 Old State Road Haubstadt, Indiana 47639

On November 22, 1920 the corporate structure at Hercules changed. The various companies (The Hercules Buggy Company, The Hercules Body Company, the Hercules Gas Engine Company, The Indiana Color and Varnish Company, the Hercules Wheel Company, The Hercules Power Plant, The Hercules Surry and Wagon Company, and the Hercules Carriage Wood-Stock Company) were merged into the Hercules Corporation. It was also about that time that Hercules became involved in the refrigeration business too.

The E model gas engine era started coming to a close late in 1921. In an eight year span, some 220,000 E models had been built along with several thousand D models and Thermoils. This figures out to be around 30,000 engines per year. Before the move to Evansville from Sparta, Michigan in late 1913, less than 3 5,000 engines were produced during the four years there.

Interestingly, production of E models did not end abruptly when production of the F models began. A study of serial numbers of known engines would indicate that both models were co-mingled for several thousand. The production of Jaeger engines also began toward the end of the E model era. They had the same dimensions and appearance (except of color) of the 1 HP Economy engines, but they were rated at 2 HP and had no model letter on the tag.

There were several changes in engine design on the F model. The most noticeable would be the use of the Webster 1A and 2C magneto system. It is shown in the accompanying illustrations. This magneto system apparently was not too satisfactory. Many F model engines in the field have either refitted to the older Webster magneto system or updated to the Wico high tension system. Observation indicates that very few other engine manufacturers switched to this new Webster system.

On all Hercules brand engines the flair on the hopper lip was eliminated. The small block engines had several other design changes. The main bearing mounts were changed to flat from the slanted design. Not only is the flair eliminated on the small Hercules hopper, the whole hopper is moved to the rear about of an inch. The small size Economy hopper is redesigned to a longer shape with a smaller opening. The oiler is relocated from behind the hopper to a pipe down through the hopper opening.