BREMEN NOISELESS CALORIC PUMPING ENGINE


| August/September 1992



Noiseless Caloric Pumping Engine

7574 S. 74 Street Franklin, Wisconsin 53132

After building models from castings of both the Ericsson Hot Air Pumping Engine and the Improved Ericsson (American Machine Co.) Hot Air Pumping Engine, I wanted to build another but different hot air engine. Having seen a Bremen engine (called Caloric by Bremen) at a show, I decided that this was it!

The Bremen Manufacturing Company of Bremen, Ohio seems to have started building their 'noiseless Caloric Pumping Engine' in 1906, after the patent was assigned in June. This patent was based on an earlier patent issued in 1896. Their six inch bore Caloric engine was advertised to lift water from 25 feet below and elevate it 75 feet above the base of the engine. This engine burned natural or manufactured gas, gasoline or alcohol. It was common for hot air pumping engines to be placed in the basement of a house, pumping water to a tank located on one of the floors above it. When starting the engine, an arrow on the flywheel showed the direction that the wheel was to be turned. Today, the Bremen is one of the more rare examples of hot air engines, partially because production was less than the three major companies which were located in the New York area.

The project began by my measuring and drawing the engine. Foundry patterns were then made of wood and metal, so the parts could all be cast. Some of the patterns had different sizes of letters attached to them to duplicate the raised lettering on the real engine. I then had several sets cast to meet the foundry's minimum order. While this was being done, the material was gathered together to make the non-cast parts, such as bearings, steel plate, rods, O-rings, etc.

This engine was a fairly simple machining job, especially if one has built either of the two model engines mentioned above. I suspect that its simplicity and lack of complicated alignment of its parts was one reason for this design on the real engine. A lathe, milling machine and drill press were used in the machining of the parts. The power cylinder should be honed. This could be done at home with a brake hone, if enough care was taken in the boring process, or it could be professionally honed by a local honing company. It is very important to have a good fit between the cylinder and piston on a hot air engine. Hot air engines have no rings and rely only on this fit and a string packing for compression.

After the parts were all machined and assembled, the day came for a test run. The gas burner was lit and after about one minute, the flywheel was turned. The engine started and soon water was being pumped through the pump and cylinder jacket. This pumping engine, like the other makes, passed the water that was being pumped through the cylinder jacket to keep the engine cool. It is hard to describe the feeling that an engine builder feels when an engine runs for the first time.