The Mobius Strip


| January/February 2001



Mobius Strip

221 North End Road Westport, Maine 04578

I have always been fascinated by a geometric oddity called the 'Mobius Strip.' It is also called a 'Unilateral Surface' because it has only one side.

The last time my wife, my son and I sawed firewood it occurred to me, as I was putting belt dressing on the belt, that a mobius strip might prove useful.

We had the old 6 HP Fairbanks-Morse belted up to the saw table and using belt dressing involved reaching inside the belt. If there is a loose wire in the belt lacing it could snag your hand or arm and gash you or pull you into the machinery. Neither prospect is very attractive, and even though I've been doing this same job for many years without a mishap, it's always an uneasy feeling.

So this time, we unlaced the belt and put a twist in it before putting the lacing pin back. Now at the lacing we apparently had the top of the belt on one side and the bottom on the other. The beauty of the arrangement is that now the belt has only one side! If you put the belt dressing on what appears to be the 'outside,' it gets to where it belongs on the pulley side of the belt (inside).

To demonstrate the principle, take a long, narrow strip of paper and tape it together like a belt, but put a 180 inch twist in one end before you tape it. Now draw a line down the center of the strip. You'll find as you proceed down the strip that you'll draw a single line that meets itself and will have covered 'both sides' of any single segment of the paper. Truly you have a 'belt' with only one side!