The 4 HP Fairbanks-Morse Type T owned and restored by Marcus Mason, Fielding, Utah.
Manufacturer: Fairbanks, Morse & Co., Beloit, Wis.
Model: Type T
Flywheel diam.: 24 inches
Flywheel width: 2-1/2 inches
If I had all the original parts for this 4 HP Fairbanks-Morse Model T, it would have stayed all original, but I had to work with what I had.
I had the block, flywheels, crank, piston, connecting rod, camshaft roller and pinion gear, but I needed to come up with the cylinder, head, valves, rocker arm, rocker arm bracket, pushrod, pushrod end, camshaft gear, governor assembly, magneto and other various pieces.
The cylinder I used was made out of 5-inch high carbon steel pipe. I welded a flange on each end to mount to the block and head. I also threaded the top end for a spark plug and lower end for an oiler.
I was able to find an original head, but the valve guide for the intake was broken off. There are three holes in the head where a cover fit over the intake valve, and I installed a new valve guide on the head. It bolted right on where the valve guide cover used to be.
I was told that the rocker arm and rocker arm bracket from a Fairbanks-Morse 4 HP Type H would work on a Type T. It did work but I had to modify the end of the pushrod where it connects to the rocker arm, making the new connector out of 1-inch round stock. It had to be modified this way so the pushrod lined up properly between the rocker arm and camshaft roller.
I found an original camshaft gear and governor assembly. The camshaft was replaced with 1-1/8-inch round stock. The old exhaust camshaft lobe was reused on the new camshaft. On the end of the camshaft was a pin that worked the igniter. This pin was replaced with a gear to run a Fairbanks-Morse R magneto for spark to the spark plug. I get a spark right where I should, just a little after top dead center on the compression stroke. Add a nice cart, some paint and there you have it.
Contact Marcus Mason at 212 S. Center St., Fielding, UT 84311 • firstname.lastname@example.org